My Repeater.net Login: A Step-by-Step Guide

A device that repeats a router’s signals is called a wireless-n WiFi repeater. And enhance the network signal in your house. The signals are picked up by the repeater router from the root router and sent out as boosted signals.

If you are looking for the best directions for setting up your Wireless-N repeater, then this is the article for you. Here, we discuss in detail how to set up and login a Wireless-N WiFi repeater at home. Let’s start:

Install Wireless-N repeater

To setup Repeater, firstly you need to install the repeater. There two methods to setup the Wireless-N Repeater are:

  • WPS (Wireless Protected Setup) Button
  • Setup Manually (access through IP like 192.168.1.1)

WPS Button

If your existing router has a WPS button, then you can easily connect the repeater to the router by using WPS button.

  1. Place the Repeater in the same room where the root router is placed.
  2. Reboot the existing router and the modem.
  3. Find the WPS button on both the root router and the repeater.
  4. First press the WPS button of the router, within two minutes press the WPS button of the Repeater
  5. It will take few second to establish a connection.

But if your router do not have WPS button, then you need to access web interface of router to WPS setup.

Setup Manually (through IP 192.168.1.1)

To setup manually, restart the root router and the modem. Connect the Wireless-N Repeater to the root router with the help of Ethernet cable. And plug in the repater to the wall socket. When you setup the repeater manually, there is no need to place the repeater close to the repeater while setup.

Access To Myrepeater.net

When the LED light of the repeater is stable, then you can access the myrepeater.net login page. Follow the steps:

  1. Find the default network name of the repeater, and connect your computer or mobile device to the network of Repeater.
  2. Open any web browser on your computer and type myrepeater.net or IP address 192.168.10.1 into the address bar.
  3. A login page will open; enter admin on fields username and password. Click on OK button
  4. On dashboard, click on SETUP WIZARD > WIRELESS REPEATER SETUP > REPEATER > ONEKEY SETTING
  5. Now choose the network of the root router that you want to extend, and enter the password of the router into the Pre-Shared Key.
  6. Click on OK and REBOOT button on screen, repeater going to reboot process. When it completes the restart process, repeater is able to extend your network.

By following these steps, you can easily adjust the settings of the repeater. Repeater works similar to Extender.

By following above given steps, you can also complete Setek WiFi extender setup, Macard WiFi extender setup, or many more that have assigned 192.168.10.1 IP Address

Reboot And Reset Repeater

Reboot – To fix some minor issues related to your Repeater, you can perform restart process on your Repeater. Simply turn off and plug out your repeater from power socket. After sometime, turn on your repeater again.

Reset – To restore the default factory settings of repeater, you can reset it. Find the reset button on the repeater, and press it for few seconds. When you press the button, it will take few minutes to complete the reset process. After reset the Repeater, you can need to re-configure your repeater to the root router and also update Firmware update of Repeater.

Conclusion

In this article, you learned what a Wireless-N Repeater is. And also know, how to setup and login to the Repeater via the URL and IP address 192.168.10.1.You just follow all the given steps carefully.

Previous Post Next Post